Micromech

X-PLUS MT – Boxed Stepping Motor Drive

  • Series of stepping motor drives with Modbus interface, direct input from the main AC power supply and STO function
  • Direct connection from the main AC power supply (110 Vac to 230 Vac)
  • Auto-Sync function available
Introduction
  • Series of stepping motor drives with Modbus interface, direct input from the main AC power supply and STO function
  • Direct connection from the main AC power supply (110 Vac to 230 Vac)
  • Auto-Sync function available
Highlights
  • Communication by means of Modbus TCP/IP interface
  • Modes of operation: PROFILE POSITION, PROFILE VELOCITY and HOMING
  • Full digital microstepping drive
  • Wide range of SANYO DENKI stepping motors to be coupled with: holding torque up to 9,2 Nm and flange size up to 86 mm
  • Easy setup by RTA Modbus configurator software
Technical Specifications
  • Communications by means of Modbus TCP/IP interface
  • Range of operating voltages: 110-230 Vac
  • Protections:
    - Protection against under-voltage and over-voltage.
    - Protection against a short-circuit at motor outputs.
    - Overtemperature protection with thermal sensor.
  • Electronic damping facility for further acoustic noise and mechanic vibrations reduction
  • External fans no needed
  • UL/CSA certified
  • Warranty 24 months
  • Wide range of motor phase setting
  • Motor current overboost
  • Different variety of HOMING operation modes
  • Encoder feedback
Model Name Drive Type Bus Voltage Range (Volt.) Phase Current Range (Amp.)  Dimensions (mm.) Suggested Motors (Flange size) 
X-PLUS MT B4 MODBUS 110 - 230 SUPPLY DIRECLTY FROM THE MAIN 2.4 - 4.0 Box 169 x 129 x 46 mm Plug_in connectors NEMA 34 (with rating for high voltage)
X-PLUS MT S4 MODBUS + STO 110 - 230 SUPPLY DIRECLTY FROM THE MAIN 2.4 - 4.0 Box 169 x 129 x 46 mm Plug_in connectors NEMA 34 (with rating for high voltage)

Downloads

Catalogue